3D
Printed Robot is home made robot fully printed on the reprap 3D printer. It is
based on arduino nano board, servos and ultrasonic sensor. It is easy to print,
assemble, small, fun and great intro into electronics and robotics.
ArduBot
is fully controlled by IR remote control and it has 3 modes:
1.Manual
control by IR remote ( forward, backward, right and left)
2.Autonomous
mode ( ArduBot navigates to avoiding obstacles and choosing the best way.)
3.Monitor
mode ( ArduBot is monitorng objects in front of the ultrasonic sensor. )
Parts
to be needed:
1)3D Print all these parts:
1x Front mount part
1x Rear mount part
1x Speaker cube part
1x Speaker grille part
1x Battery holder part
1X Battery pack part
1x hc-sr04 front part
1x hc-sr04 back part
1x small wheel holder part
1x small wheel holder top part
1x small wheel part
2x main wheel part
1)3D Print all these parts:
1x Front mount part
1x Rear mount part
1x Speaker cube part
1x Speaker grille part
1x Battery holder part
1X Battery pack part
1x hc-sr04 front part
1x hc-sr04 back part
1x small wheel holder part
1x small wheel holder top part
1x small wheel part
2x main wheel part
2)
Parts you need to buy:
1x Ultrasonic sensor HC-SR04
2x Servo motor Futaba S3003
1x Micro servo motor SG90
1x Arduino Nano rev. 3
1x IR receiver TSOP382 or another
1x PC Speaker
4x AAA battery
1x Ultrasonic sensor HC-SR04
2x Servo motor Futaba S3003
1x Micro servo motor SG90
1x Arduino Nano rev. 3
1x IR receiver TSOP382 or another
1x PC Speaker
4x AAA battery
Instructions:
1)Hack
Futaba servos so they can turn 360 degrees, instructions are for exampe on: https://www.youtube.com/watch?v=SK8mhnEzcvY
2) Assembly all parts together
3) Connect everything with schematic on https://github.com/davidhrbaty/ArduBot
4) Modify program to your IR remote controll
5) Upload program to Arduino which you can download from https://github.com/davidhrbaty/ArduBot
6) Insert batteries into battery pack
7) Ready to go :-)
2) Assembly all parts together
3) Connect everything with schematic on https://github.com/davidhrbaty/ArduBot
4) Modify program to your IR remote controll
5) Upload program to Arduino which you can download from https://github.com/davidhrbaty/ArduBot
6) Insert batteries into battery pack
7) Ready to go :-)
You
can download files here: https://www.thingiverse.com/thing:603907/zip
0 comments:
Post a Comment